Encoder Based DC Servo Drive

Ø DC Brushless – no brush maintenance – no maintenance Ø No oiling required Ø Start to 33.333 rpm in 3.0 – 3.8 seconds, 45 RPM 4 – 5 seconds, 78 RPM Ø DC brushless Ø High torque 3 phase Ø Brushless servo motor Ø Non cogging 24 volt Ø Rated at a full 1/8 horsepower 6 amp Ø Micro processor controlled motor has built in encoder Ø PPM digital signal is processed 1000/pulses per platter revolution Ø Torque applied if weight is added Ø XLR Connector – 7 Pin 4 FT controller cable (plugs in back of controller